Installation of DragonFly 4.0.0 RC

[Sascha Wildner]

On Thu, 30 Oct 2014 04:09:05 +0100, Mehmet Erol Sanliturk  
<m.e.sanliturk at gmail.com> wrote:

> Dears All ,
>
>
> During installation of DragonFly 4.0.0 RC , the following points may
> require improvement :
>
>
> 1. USB network cards are NOT recognized during install boot and
> configuration ( and after
>    reboot in 3.8.2  by ifconfig )

There could be 2 reasons I can think of:

* If it is a USB3 port, the port might not work at all until xhci(4) is  
loaded. We don't load xhci by default (but I really think we should start  
doing so).

* The adapter is not supported. Right now, we have only 2 drivers (3, if  
you count urndis(4)): axe(4) and udav(4).

What adapter is it that you have?

Sascha