Installation of DragonFly 4.0.0 RC
justin at shiningsilence.com
Thu Oct 30 15:32:45 PDT 2014
I can't help on the USB network devices; I haven't been using any but I
thought there were some models that worked.
Network devices getting specific names instead of the generic eth0, eth1,
etc found on Linux is actually a common BSD practice. It is in fact touted
as an advantage. If you look at your dmesg, you should be able to tell
which is which, and there will be corresponding man pages to go with the
On Wed, Oct 29, 2014 at 11:09 PM, Mehmet Erol Sanliturk <
m.e.sanliturk at gmail.com> wrote:
> Dears All ,
> During installation of DragonFly 4.0.0 RC , the following points may
> require improvement :
> 1. USB network cards are NOT recognized during install boot and
> configuration ( and after
> reboot in 3.8.2 by ifconfig )
> 2. Network devices are listed only by a few character names , for example
> : re0 , faith0 .
> Their product names are important because ( to associate the listed
> names to actual
> devices are not possible ) except rare cases .
> Thank you very much .
> Mehmet Erol Sanliturk
-------------- next part --------------
An HTML attachment was scrubbed...
More information about the Users