live-cd

[Ludo Beckers]

You are absolutely right; after reinstalling the new virtual hard disk, I
had forgotten to do that again.
I'll proceed with the earlier instructions from here.

Ludo
www.potingue.be


On Sat, Mar 29, 2014 at 9:00 AM, karu.pruun <karu.pruun at gmail.com> wrote:

> On Fri, Mar 28, 2014 at 11:40 PM, Ludo Beckers wrote:
>
> Since that page says: <<To ensure *pkgng* on a DragonFly BSD 3.4 or
>> higher system is ready for use, run the following BEFORE you try to use
>> pkg the first time:>>
>>
>> I took out the DragonFly from the VM and loaded it fresh.
>>
>> Then after
>>
>> # cd /usr
>> # make dports-create
>> I'm stuck with a message that says it could not create work tree dir '/usr/dports'.
>> : Read-only file system*** Error code 128
>>
>>
> Just to check: did you actually create a new virtual hard disk and install
> DFly on that or are you running the live cd in your VM? If the latter, then
> you cannot write anything on it; you can't install any packages since that
> live cd is a read-only filesystem.
>
> Peeter
>
> --
>
>
>
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.dragonflybsd.org/pipermail/users/attachments/20140329/60de3a63/attachment-0002.html>