mount question

[Alex Hornung]

 Hi Andrei,

BSDs use disklabels on top of what one calls partitions. DragonFly in 
particular uses disklabel64 which Linux has no support for as far as I know.

So the structure would be:

-------
| Partition
|   --------------
|   | disklabel partition
|   |
|   --------------
|   | disklabel partition
|   |
|   --------------
-----------
| Partition
| ....
Kind regards,
Alex Hornung
On 12/10/2010 11:02, Andrei Lomov wrote:
I had installed DragonFly 2.6.3 on 40Gb IDE ATA slave drive (on second (ATA)
controller)
During DragonFly installation it ask to set ufs instead of hummer (in view
of lesser 50 Gb drive space) and I agree.
I don't install any bsd boot loaders preferring to setup lilo.

In linux fdisk, bsd partition looks fine:
# fdisk /dev/hdb
...
Disk /dev/hdb: 40.0 GB, 40020664320 bytes
256 heads, 63 sectors/track, 4846 cylinders
Units = cylinders of 16128 * 512 = 8257536 bytes
Disk identifier: 0x00000000
    Device Boot      Start         End      Blocks   Id  System
/dev/hdb1   *           1        4846    39078112+  a5  FreeBSD


To configure lilo I try to mount bsd partition from linux
but it fails:
# mount -t ufs -o ufstype=44bsd /dev/hdb1 bsd
mount: wrong fs type, bad option, bad superblock on /dev/hdb1,
        missing codepage or helper program, or other error
        In some cases useful info is found in syslog - try
        dmesg | tail  or so
I'm newbie in bsd and need an advice

Thanks in advance

--
Andrei