boot failure with acpi...
dillon at apollo.backplane.com
Sun Oct 30 09:03:19 PST 2005
:i updated my src tree then recompiled my kernel earlier but after
:rebooting it failed, so what i did was reboot but this time without
:acpi mode just to try and evrything's all ok again. i dont know what
:to do with it so i just want to report it, hope this helps somehow.
:below are the errors that appeared...
:Fatal trap 12: page fault while in kernel mode
:fault virtual address # 0x10
:fault code # supervisor read, page not present
:instruction poiuter # 0x8:0xc019d4c1
:stack pointer # 0x10:0xc04cbc78
:frame pointer # 0x10:0xc04cbc8c
:code segment # base 0x0: limit 0xfffff, type 0x1b
: # DPL 0, pres 1, def32 1 , gran 1
:process eflags # interrupt enabled, resume, IOPL = 0
:current process # 0 (swapper)
:current thread # pri 12
:trap number # 12
:panic: page fault
:ps. im using 1.3.7-HEAD in shuttle xpc ss56g system
Please run 'nm -n /kernel' and extract the addresses both before and
after 0xc019d4c1, and post that. If I can't figure it out from that
I'll probably need more info, like a DDB backtrace.
Make sure that when you recompiled your kernel, you did a full recompile
and install of the kernel using the make buildkernel and installkernel
targets, rather then just 'make' inside the kernel's object tree.
<dillon at xxxxxxxxxxxxx>
More information about the Users