1.0-RC2 doesn't boot on T42p

[Matthew Dillon]

:RC2 doesn't boot on my T42p. It crashes (Page fault, Trap 12) after loading
:kernel, leaving critical section  and enabling interrupts :(.
:This also happens with acpi disabled.
:
:Any hints how to debug this crash? I have no serial in my laptop :(
:
:Best Regards,

    It sounds like you got a DDB> prompt, so what you need to do is 
    write down the register information starting at the 'Page fault' line,
    e.g.:

Fatal trap 12: page fault while in kernel mode
fault virtual address   = ...
fault code              = ...
instruction pointer     = 
stack pointer           = 
frame pointer           = 
code segment            = 
                        = 
processor eflags        = 
current process         = 
current thread          = 
interrupt mask          = ... 
panic: from debugger

    Then, at the DDB> line you need to type 'trace' and write down the
    procedural backtrace.  The most important information are the procedure
    names and the instruction offset at the end of each line.

					-Matt
					Matthew Dillon 
					<dillon at xxxxxxxxxxxxx>