dfly 2.4.1 does not like HP DL360G4p and Smart Array 6400 with MSA20

Simon 'corecode' Schubert corecode at fs.ei.tum.de
Tue Oct 20 02:57:04 PDT 2009


Sepherosa Ziehau wrote:
2009/10/19 Tomaž Borštnar <tomaz.borstnar at over.net>:
Hello!

       I have a HP DL360G4p machine with 5 gigs of RAM, internal SATA disk
and HP SmartArray 6400 controller (2 channels) with 6400EM card (additional
2 channels attached as daughter card) with MSA20 enclosure with SATA disks -
configured as 4 volumes. Install went fine, but dmesg prints some errors
(full dmesg output attached), but here are relevant parts:
bge0: <Broadcom BCM5704C Dual Gigabit Ethernet> mem 0xfddf0000-0xfddfffff
irq 7 at device 2.0 on pci2
bge0: CHIP ID 0x21000000; ASIC REV 0x02; CHIP REV 0x21; PCI-X
alignment check failed
miibus0: <MII bus> on bge0
brgphy0: <BCM5704 10/100/1000baseT PHY> on miibus0
brgphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
1000baseT-FDX, auto
bge0: MAC address: 00:15:60:0f:b0:e8
bge1: <Broadcom BCM5704C Dual Gigabit Ethernet> mem 0xfdde0000-0xfddeffff
irq 7 at device 2.1 on pci2
bge1: CHIP ID 0x21000000; ASIC REV 0x02; CHIP REV 0x21; PCI-X
alignment check failed
alignment check failed
miibus1: <MII bus> on bge1
brgphy1: <BCM5704 10/100/1000baseT PHY> on miibus1
brgphy1:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
1000baseT-FDX, auto
bge1: MAC address: 00:15:60:0f:b0:e7
I think you mean the "alignment check failed", it is quite common and
you can jut ignore them
Maybe we should remove the message then? :)

cheers
  simon
--
  <3 the future  +++  RENT this banner advert  +++   ASCII Ribbon   /"\
  rock the past  +++  space for low CHF NOW!1  +++     Campaign     \ /
Party Enjoy Relax   |   http://dragonflybsd.org      Against  HTML   \
Dude 2c 2 the max   !   http://golden-apple.biz       Mail + News   / \





More information about the Bugs mailing list