freeze on reboot

[Steve Mynott]

On Sun, 4 Jul 2004 10:46:54 -0700 (PDT), Matthew Dillon
<dillon at xxxxxxxxxxxxxxxxxxxx> wrote:
> 
> :I just installed RC1 fine on a new machine except for "reboot" doesn't
> 
> 
> :actually reboot but it hangs after printing the usual shutdown
> :messages.
> :
> :Is there any way I could supply further info on this issue by entering
> :a debugger through a key sequence at this point or running gdb on a
> :kernel or something?
> :
> :-- Steve
> 
>     Do you have any cardbus cards pugged in on this machine?  If so try
>     unplugging the card after the hangs and see if that unhangs it.
> 
>     If not then the question is whether ctl-alt-esc works.
> 
>     Also, try the latest cvsup/source tree.  A bunch of stuff has gone in
>     since RC1 (though not anything that would necessarily fix a
>     freeze-on-reboot problem).  I am going to roll RC2 later today.

If I remove the wireless card (a pccard bizarrely in a PCI bridge
card)  then the system reboots correctly.

 dmesg follows:

Copyright (c) 2003, 2004 The DragonFly Project.
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
DragonFly 1.0-RC2 #3: Wed Jul  7 19:51:04 BST 2004
    root at xxxxxxxxxxxxxxxxx:/usr/obj/usr/src/sys/GENERIC
CPU: AMD Athlon(tm)  (1100.05-MHz 686-class CPU)
  Origin = "AuthenticAMD"  Id = 0x662  Stepping = 2
  Features=0x383fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CM
OV,PAT,PSE36,MMX,FXSR,SSE>
  AMD Features=0xc0480000<MP,AMIE,DSP,3DNow!>
real memory  = 268369920 (262080K bytes)
avail memory = 250171392 (244308K bytes)
Preloaded elf kernel "/kernel" at 0xc05c3000.
Pentium Pro MTRR support enabled
md0: Malloc disk
pcibios: BIOS version 2.10
Using $PIR table, 10 entries at 0xc00f80a0
npx0: <math processor> on motherboard
npx0: INT 16 interface
Using MMX optimized bcopy/copyin/copyout
pcib0: <Host to PCI bridge> at pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
agp0: <VIA Generic host to PCI bridge> mem 0xe0000000-0xe3ffffff at device 0.0 o
n pci0
pcib1: <PCI to PCI bridge (vendor=1106 device=b099)> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <NVidia model 0111 graphics accelerator> at 0.0 irq 11
cbb0: <RF5C475 PCI-CardBus Bridge> irq 10 at device 9.0 on pci0
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
installed MI handler for int 10
pci0: <unknown card> (vendor=0x1274, dev=0x5000) at 10.0 irq 12
isab0: <PCI to ISA bridge (vendor=1106 device=3074)> at device 17.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <VIA 8233 ATA100 controller> port 0xff00-0xff0f at device 17.1 on pci0
ata0: at 0x1f0 irq 14 on atapci0
installed MI handler for int 14
ata1: at 0x170 irq 15 on atapci0
installed MI handler for int 15
uhci0: <VIA 83C572 USB controller> port 0xcc00-0xcc1f irq 9 at device 17.2 on pc
i0
installed MI handler for int 9
usb0: <VIA 83C572 USB controller> on uhci0
usb0: USB revision 1.0
uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhub0: port error, restarting port 1
uhub0: port error, giving up port 1
uhci1: <VIA 83C572 USB controller> port 0xd000-0xd01f irq 9 at device 17.3 on pc
i0
usb1: <VIA 83C572 USB controller> on uhci1
usb1: USB revision 1.0
uhub1: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
uhub1: port error, restarting port 1
uhub1: port error, giving up port 1
uhci2: <VIA 83C572 USB controller> port 0xd400-0xd41f irq 9 at device 17.4 on pc
i0
usb2: <VIA 83C572 USB controller> on uhci2
usb2: USB revision 1.0
uhub2: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub2: 2 ports with 2 removable, self powered
uhub2: port error, restarting port 1
uhub2: port error, giving up port 1
pci0: <unknown card> (vendor=0x1106, dev=0x3059) at 17.5 irq 12
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
installed MI handler for int 6
fdc0: FIFO enabled, 8 bytes threshold
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
installed MI handler for int 1
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
uhub2: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub2: 2 ports with 2 removable, self powered
uhub2: port error, restarting port 1
uhub2: port error, giving up port 1
pci0: <unknown card> (vendor=0x1106, dev=0x3059) at 17.5 irq 12
fdc0: <NEC 72065B or clone> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
installed MI handler for int 6
fdc0: FIFO enabled, 8 bytes threshold
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> flags 0x1 irq 1 on atkbdc0
kbd0 at atkbd0
installed MI handler for int 1
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
installed MI handler for int 4
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
installed MI handler for int 3
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (ECP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/16 bytes threshold
ppbus0: <Parallel port bus> on ppc0
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
installed MI handler for int 7
installed MI handler for int 0
wi0: <WaveLAN/IEEE> at port 0x100-0x13f irq 10 function 0 config 1 on pccard0
wi0: using Lucent Technologies, WaveLAN/IEEE
wi0: Lucent Firmware: Station 6.16.01
wi0: MAC address: 00:02:2d:22:5e:f6
ad0: 9671MB <IBM-DTTA-351010> [19650/16/63] at ata0-master UDMA33
ad1: 19541MB <Maxtor 2B020H1> [39703/16/63] at ata0-slave UDMA100
ad2: 19541MB <Maxtor 2B020H1> [39703/16/63] at ata1-master UDMA100
Mounting root from ufs:/dev/ad0s1a