pciconf -lv returns device not configured & pauze when booting on HP LP1000r

[YONETANI Tomokazu]

On Tue, Aug 10, 2004 at 07:35:11PM +0900, YONETANI Tomokazu wrote:
> On Tue, Aug 10, 2004 at 11:31:28AM +0200, Martin P. Hellwig wrote:
> > However I have cvsupped to the latest current (using the default gcc).
> > And build a new GENERIC, the behaviour is still the same though, here is 
> >  the report.
> > 
> > Debug break in the boot at:
> > 
> > acpi0: <HP HWPS213> on motherboard
> > AcpiOSDerivedPciId: bus 0 dev 15 func 0
> > installed MI handler for int 9
> > Debugger("Executed AML Breakpoint opcode")
> > Stopped at      Debugger+0x35:  movb    $0,in_Debugger.348
> > 
> > typing continue fully boots the system.
> 
> Because you actually have BreakPoint in your ASL
> 
>             Method (_INI, 0, NotSerialized)
>             {
>                 BreakPoint
>                 Store (BUSN, _BBN)
>                 Store (\_SB.PCI0.FN1.BUSN, \_SB.PCI1._BBN)
>                 Store ("PCI0 Bus numbers:", Debug)
>                 Store (_BBN, Debug)
>                 Store ("PCI1 Bus numbers:", Debug)
>                 Store (\_SB.PCI1._BBN, Debug)
>             }
> 
> Any chance you have
>   debug.acpi.debugger="init"
> in your /boot/loader.conf? If so, please try commenting it out.

Argh, please disregard this bogus message. Remove the `BreakPoint' line above,
recompile your ASL, and install the new DSDT according to our handbook
(http://forknibbler.com/handbook/acpi-debug.html).