<div dir="ltr"><div dir="ltr">On Thu, Jul 1, 2021 at 3:00 PM Matthew Dillon <<a href="mailto:dillon@backplane.com">dillon@backplane.com</a>> wrote:<br></div><div class="gmail_quote"><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="ltr">Upgrade to 6.0 for sure, as it fixes at least one bug in HAMMER2, to eliminate that possibility. </div></blockquote><div><br></div><div>Yes, both the previous installation and the one I put together yesterday were running 6.0. The previous install had been upgraded to 6.0 when 6.0 was released (or within a couple of days).</div><div> </div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="ltr">RAM is a possibility, though unlikely.  If you are overclocking, turn off the overclocking.  An ovewrclocked CPU can introduce corruption more easily than overclocked ram can.</div></blockquote><div><br></div><div>Not overclocking. RAM in this machine is non-ECC: I could imagine a bit error slipping into a checksum, though.</div><div><br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex"><div dir="ltr">And check the dmesg for any NVME related errors.</div></blockquote><div><br></div><div>No NVMe related errors appeared in the dmesg. That a completely separate NVMe part would exhibit the same problem would tend to indicate a hardware error outside of the storage device itself (RAM, bad CPU, I suppose, or a signal integrity issue when seating the NVMe part) or a software bug. That the system had previously been running the same version of the software for over a month without issue, and a fresh install popped up the same errors on the same hardware (modulo the new storage device) would suggest some sort of hardware issue.</div><div><br></div><div>I'm going to run a memtest and see if I can get an NVMe diagnostic to run somehow.</div><div><br></div><div>        - Dan C.</div><div><br></div></div></div>