ath(4) at boot time

[Francis Gudin]

On 19-07-2007, Sepherosa Ziehau <sepherosa at gmail.com> wrote:
> This should have been fixed on HEAD.  Please test to verify.

It's loading fine now:

Preloaded elf kernel "/kernel" at 0xc05e4000.
Preloaded elf module "/modules/if_ath.ko" at 0xc05e4210.
wlan: <802.11 Link Layer>
ath_hal: 0.9.20.3 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413,
RF5413)
ath_rate: version 1.2 <SampleRate bit-rate selection algorithm>
Preloaded elf module "/modules/wlan.ko" at 0xc05e42b8.
Preloaded elf module "/modules/ath_rate.ko" at 0xc05e4360.
Preloaded elf module "/modules/ath_hal.ko" at 0xc05e440c.
Preloaded elf module "/modules/acpi.ko" at 0xc05e44b4.

then everything's OK:

ath0.cardbus0.cbb0.pci0.pcib0.legacypci0.nexus0.root0
ath0: <Atheros 5212> [tentative] mem 0x88010000-0x8801ffff irq 10 at
device 0.0 on cardbus0
ath0: four TX queues
ath0: bpf attached
ath0: MAC address: 00:0f:3d:ab:ce:f4
ath0: bpf attached
ath0: bpf attached
ath0: 11b rates: 1Mbps 2Mbps 5.5Mbps 11Mbps
ath0: 11g rates: 1Mbps 2Mbps 5.5Mbps 11Mbps 6Mbps 9Mbps 12Mbps 18Mbps
24Mbps 36Mbps 48Mbps 54Mbps
ath0: mac 5.9 phy 4.3 radio 4.6
ath0: Use hw queue 1 for WME_AC_BE traffic
ath0: Use hw queue 0 for WME_AC_BK traffic
ath0: Use hw queue 2 for WME_AC_VI traffic
ath0: Use hw queue 3 for WME_AC_VO traffic
ath0: Use hw queue 8 for CAB traffic
ath0: Use hw queue 9 for beacons
ath0: <Atheros 5212> [attached!] mem 0x88010000-0x8801ffff irq 10 at
device 0.0 on cardbus0

Thank you very much !

Best regards,
--
Francis