Network Slowdowns

Bill Hacker wbh at conducive.org
Fri Oct 13 15:11:08 PDT 2006


Paul Allen wrote:

See commit relating to revision 1.258 of if_fxp.c (in FreeBSD)

There is some evidence that this problem is not localized to fxp but common
to many driver implementations.
	
----- Forwarded message from John-Mark Gurney <gurney_j at xxxxxxxxxxxxxxxxxx> -----
Jeremy Chadwick wrote this message on Thu, Oct 05, 2006 at 09:08 -0700:
The problem in that case turned out to be duplex-related.  Both
boxes were auto-negotiating with the Cisco switch correctly, and
indeed the Cisco labelled them as auto-100/full, but as anyone who
is familiar with Ciscos knows, auto-negotiation on Catalysts is
far from reliable.  Both boxes reported auto-neg and being at 100/full
as well.  I ended up hard-setting the boxes to use 100/full, and
set the switch ports to 100/full, then rebooted both boxes (yes,
this is sometimes required, as driver auto-neg code is a bit tweaky);
voila, problem fixed.


It appears that some ethernet drivers don't reset the phy (bring the
link down) when changing media (duplex setting, etc)..  This means that
if you boot w/ autoselect, and the switch autoselects to 100/full, but
then later change it to 100/full (w/ autoselect off) it will work fine..
but then if the cabel is pulled, or the switch resets, it attempts to
reautoselect, but falls back to 100/half while you are still running
100/full...
As you can imagine, it causes a very hard to track down problem since
the time it breaks is not readily apparent...
First two whole generations of Intel 10/100 did that, *even if* set to fixed 
100-FDX.

Killer wasn't just cable move - one learned to check on that.
But they went walk-about after a power-outage on the 'SWUB' as well.
First generation just stopped talking altogether.

Switched to DEC until they were bought by Intel, then RealTek, AKA el-cheapo.

Back with Intel and Broadcom Gig-E now, and no longer a hassle.

an ifconfig <iface> down; ifconfig <iface> up may help resolve this
issue if you are not sure...
I have just committed a patch to fxp0 to do this...

Good news!

Bill





More information about the Users mailing list