Buffalo/Broadcom wireless N card

Walter walter at spam.no
Sat May 24 05:40:48 PDT 2008


Chris Turner wrote:
Sepherosa Ziehau wrote:
If you want 11n support, you can use freebsd current; It has mwl(4),
wasn't able to find a concrete reference to this in the fbsd sources - 
is this the correct driver name?

(cursed with a broadcom 11n card here too)

cheers

- Chris
Fwiw, I solved this using FreeBSD's 'ndis' - DF maybe ought
to pull that in??
Here's my post to the FBSD Questions list giving the solution
I found (with the List's help), if you don't mind pulling in
the Windows XP driver:
---

The answer, maybe not the BEST answer, but the answer that
works, is to use the Windows XP driver and FBSD's 'ndis'.  My
goal was to build a FBSD router with wireless access to my COTS
wireless router to provide network access in another part of the house.
Get the driver files (.sys & .inf) either from the CD that came with
the card or from the Buffalo web site:
http://www.buffalotech.com/support/downloads/
Then, per instructions from the Handbook (11.8.2)
http://www.freebsd.org/doc/en_US.ISO8859-1/books/handbook/config-network-setup.html
run 'ndisgen' on the driver files:
# ndisgen netg300n.inf cbg300n.sys

A .ko file will be generated: cbg300n_sys.ko.  It can be loaded
using 'kldload ./cbg300n_sys.ko' but I wanted it loaded at boot.
So, as 11.8.2 says, copy this file to /boot/modules and add the
following line to /boot/loader.conf:
  cbg300n_sys_load="YES"

Also, as I wanted WPA encryption, I added two other lines to
loader.conf:
  wlan_ccmp_load="YES"
  wlan_tkip_load="YES"
The wireless setup instructions are in the handbook section 29;
http://www.freebsd.org/doc/en_US.ISO8859-1/books/handbook/network-wireless.html
Then in /etc/rc.conf add this:
  ifconfig_ndis0="WPA DHCP"
The device 'ndis0' is created by the ndis driver when it handles a
Windows driver.  I guess if you have more than one Windows
device and driver you get to sort out the various ndis0/1/2/3/4/5/etc.
If you don't want WPA just use "DHCP" and you don't need the
two extra lines above in loader.conf.
For WPA you need to create the WPA config file:
/etc/wpa_supplicant.conf:
  network={
     ssid="<your wireless network name>"
     psk="<your personal access key>"
  }
---

And then it should work.





More information about the Kernel mailing list