network01.patch - MPSAFE network interrupt

[Glenn]

I don't see your em interface listed below...it should say something
like

em0     .... etc...

On Thu, 24 Nov 2005 23:44:40 +0100, "Tomaž Borštnar"
<tomaz.borstnar at xxxxxxxx> said:
> Matthew Dillon pravi:
> > 	(3) ON SMP systems Make sure there are no other drivers sharing
> > 	    the network interrupt.  vmstat -i will tell you.  For testing
> > 	    purposes, remove any other non-network drivers that share the
> > 	    interrupt.
> 
> 
>  > vmstat -i
> interrupt                   total       rate
> clk                        100608        280
> ohci0/ohci1                     1          0
> sio0                          127          0
> irq7                            1          0
> acpi0                           0          0
> ata0                            0          0
> ata1                           86          0
> bge0                            0          0
> bge1                         2627          7
> ips0                         1870          5
> irq20                          45          0
> irq23                          53          0
> swi_siopoll                     0          0
> swi_crypto/swi_camnet           0          0
> swi_cambio                      0          0
> swi_vm                          0          0
> swi_taskq                       0          0
> Total                      105418        293
> 
> How do I get interrupt number from this ouput?
> 
> Tomaž
-- 
  Glenn
  bsdgeek at xxxxxxxxxxxxx

-- 
http://www.fastmail.fm - Same, same, but different?